ADD TO DEL.ICIO.US

Guide to Opening Your Wii

Last Updated: (10-02-2009 at 09:10)

Step 1 Step 2
opening a wii part 1 opening a wii part 2
Using your Philips Screwdriver to remove the battery cover Remove the battery and cover and put it off to the side.
Step 3 Step 4
opening a wii part 3 opening a wii part 4
 Remove the three small Phillips screws that hold the Wii's black port cover. Note one screw is longer than the other. Once you remove the black port cover, you'll find a mix of Tri-wing and Phillips screws that need to be removed.
Step 5 Step 6
opening a wii part 5 opening a wii part 6
Remove the stickers on each end of the face panel Remove the 2 Tri-wing screws, that secure the Wii's front panel.
Step 7 Step 8
opening a wii part 7 opening a wii part 8
Remove the stickers on the screw hidden on the side and remove the Tri-wing screw Remove the stickers on the screw hidden on the back and remove the philips screw
Step 9 Step 10
opening a wii part 9 opening a wii part 10
With the side and face plate screws removed, you can gently detach the face plate from the Wii.
Gently detach and remove the face plate.		 With the face plate removed, you can remove the remaining two Tri-wing screws that secure the Wii's plastic case. These are found under the two rubber pads near the back of the Wii's bottom shell
Step 11 Step 12
opening a wii part 11 opening a wii part 12
Top cover removed Remove the screws holding down the metal shield and you will see the Wii's drive, two wireless antenna, cooling fan, and air intake cover.
Step 13 Step 14
opening a wii part 13 opening a wii part 14
Remove ALL 4 drive screws to lift the drive out.
Step 15 Step 16
opening a wii part 15 opening a wii part 16
The drive is connected to the main unit by a thin ribbon cable and larger power cable. By disconnecting the POWER cable you can lift the drive and set the drive flat.

 
 
Home
We Compare:-
Terms and Conditions, Disclaimer, Shop Oweners/Merchants, Contact Us, SiteMap
© 2009 Wiiarecheap.com